Disk Show Partition - Adaptec RAID 2810SA Software Reference Manual

disk show partition

To display a list of partitions on the disks attached to the currently
opened controller, use the disk show partition command.
Syntax
disk show partition
Examples
The following example shows a sample output from the disk show
partition command:
AAC0>disk show partition
Executing: disk show partition
Scsi Partition Array
C:ID:L Offset:Size Num Type
------ ------------- --- ------ --- ------ ---
0:02:0 64.0KB:20.0MB 0
The following sections provide more information on the columns
that the disk show partition details command displays.
The SCSI C:ID:L Columns
The C:ID:L column displays the SCSI channel number, the device
ID, and the device logical unit number for each disk on the currently
opened controller.
In the example, the command displays the SCSI channel number, the
device ID, and the device logical unit number for one disk (0:02:0)
on the currently opened controller.
The Partition Offset:Size Column
The Partition Offset:Size column displays the offset (in bytes) into
the device and the size of the partition (in bytes). In the example, the
offset is 64.0 KB and the size is 20.0 MB.
If a partition is dead, the ":" (colon) in the Partition Offset:Size
column changes to a "!" (exclamation point). See the disk remove
(page
dead_partitions
dead partitions.
MultiLevel
Num Type R/W
Volume 0 None RW
7-9) command for more information on
disk Commands
7-16