container remove file_system
To remove the file system from an array, use the container
remove file_system command. Use this command when the file
system on the array is no longer needed.
This command fails if there are open files on the array.
Command Availability
This command and its associated switches (if any) are supported on
the following operating systems:
Windows NT
Windows 2000 (basic disk only)
Windows XP (basic disk only)
Syntax
container remove file_system {container}
Parameters
{container}
Specifies the ID number (0 to 63) of the array from which you
want to remove the file system.
Examples
Before removing a file system from an array, use the container
list command to obtain information about any existing arrays.
As the following example shows, there is an array 0 (a volume set)
on this controller:
AAC0>container list
Executing: container list
Num
Total
Oth Stripe
Dr Label Type
Size
Ctr Size
-- ----- ------ ------ --- ------ ------- ------ -------------
F: 0
Volume 10.0MB
container Commands
Scsi
Partition
Usage
C:ID:L Offset:Size
NTFS
0:02:0 64.0KB:
10.0MB
5-88