Adaptec RAID 2810SA Software Reference Manual page 222

Table 9-1. Task Types (Continued)
Task Type Meaning
Verify A verify with no repair of bad blocks task is running on the
specified SCSI disk. When the verify with no repair of bad
blocks task completes, the specified SCSI disk's blocks were
verified without repairing any detected defects. The verify
with no repair of bad blocks task runs as a result of using
the
disk verify
/repair
Or, a verify with repair of bad blocks task is running on the
specified SCSI disk. When the verify with repair of bad
blocks task completes, the specified SCSI disk's blocks were
verified and any detected bad blocks were repaired. The
verify with repair of bad blocks task runs as a result of
using the
.
switch
Zero A clear disk task is running on the specified SCSI disk.
When the clear disk task completes, the specified SCSI disk
is cleared (that is, all data is erased and cannot be
recovered). The clear disk task runs as a result of using the
disk zero
The Done% Column
The Done% column displays a running percentage value that
indicates the progress of the currently running task. The display
shows the percentage in tenths of a percent increments. The
currently running task is complete when the Done % column
displays 100%.
The Array Column
The Array column displays the ID number of the array associated
with the task (if any). In the example, the array's ID is 0 (zero).
The State Column
The State Column displays the state of the task. Table 9-2 describes
the state values that the task list command can display.
command without specifying the
switch.
command with the
disk verify
command.
task Commands
/repair
9-5