container remove drive_letter
To remove a drive letter, use the container remove
drive_letter command. To use the container remove
drive_letter command, none of the array's files can be open.
Command Availability
This command and its associated switches (if any) are supported on
the following operating systems:
Windows NT
Windows 2000 (basic disk only)
Windows XP (basic disk only)
Syntax
container remove drive_letter {string}
Parameters
{string}
Specifies the drive letter to remove. The colon (:) after the drive
letter is optional.
Examples
Before removing a drive letter from an array, use the container
list command to obtain information about any existing arrays. As
the following example shows, there is an array 0 (a volume set) on
this controller with a drive letter
AAC0>container list
Executing: container list
Num
Total
Oth Stripe
Dr Label Type
Size
Ctr Size
-- ----- ------ ------ --- ------ ------- ------ -------------
F: 0
Volume 10.0MB
The following example removes drive letter
AAC0> container remove drive_letter F
Executing: container remove drive_letter "F"
container Commands
:
F
Scsi
Partition
Usage
C:ID:L Offset:Size
NTFS
0:02:0 64.0KB: 10.0MB
from array 0:
F
5-84