Related Information - Adaptec RAID 2810SA Software Reference Manual

The following list describes the columns that contain information as
the result of creating a volume set with the container create
volume command:
The Num Label column displays the ID number of the newly
created volume set, which in the example is 0.
If you specify a label when creating the volume set, it appears
in this column. Because no label was specified when the
volume set was created, no label appears in the column.
On UNIX systems, the root special file associated with the
array also appears in this column.
The Type column displays Volume to indicate that the newly
created array is a volume set.
The Total Size column displays the value(s) specified in the
parameter(s), which in the example is 15.0 MB.
free_space
The Usage column displays None to indicate that the newly
created volume set does not have a file system on it. To create
an NTFS or FAT file system on an array, use the
command.
format
The Scsi C:ID:L column displays the SCSI device ID for the
disk on which you created the volume set, which in the
example is 0:02:0.
The Partition Offset: Size column displays the partition offset
and the size of the newly created volume set's partition, which
in the example are 64.0 KB and 15.0 MB. The size is the size you
specified in the
free_space

Related Information

container commands:
container extend volume
container format
container list
container promote
container set cache
container set label
parameter(s).
(page 5-50)
(page 5-54)
(page 5-54)
(page 5-69)
(page 5-97)
(page 5-107)
container Commands
container
5-38