Adaptec RAID 2810SA Software Reference Manual page 38

If the computer name has a dash (-) in the name (for example,
proj-athena), enclose the entire string within quotes. For
example:
"\\proj-athena\aac0"
Switches
/readonly{=boolean}
Specifies whether to open the controller for read-only access. A
value of TRUE indicates the CLI opens the controller for read-
only access.
If you do not specify this switch, it defaults to /
readonly=FALSE (which means the CLI opens the controller
for read/write access).
Note that if you open the controller with read-only access, you
can use only the commands that do not change the controller
configuration.
/domain{=string}
Specifies the domain (the local domain or a trusted domain) in
which the specified computer that contains the controller
resides. If you do not specify this switch, the CLI assumes the
local domain.
This switch is supported on the following operating systems:
Windows NT
Windows 2000 (basic disk only)
Windows XP (basic disk only)
Note:
You can open controllers for read-write access in any
GUI or CLI session only once per controller. Thereafter, you
(and other users) can open and access the previously
opened controller only in read-only mode.
General Control Commands
4-4