Adaptec RAID 2810SA Software Reference Manual page 98

The Partition Offset:Size Column
This column displays the offset and size for the underlying
partitions.
If a partition is dead, the ":" (colon) in the Partition Offset:Size
column changes to a "!" (exclamation point). See the disk remove
dead_partitions
(page
on dead partitions.
The State Column
This column displays information about the state of the array.
Specifically, the column can display the items listed in Table 5-3.
Table 5-3. Container State Items
Container State Meaning
Indicates that the array is the copy array in an array
Copy
reconfiguration operation.
Indicates the creation of a mirror set.
Create
Indicates that the array is the destination array in an
Dest
array reconfiguration operation.
Indicates that the mirror set is in the normal state.
Normal
Indicates that the array is a RAID-5 set in an array
Raid5
reconfiguration operation.
Indicates that the array is the source array in an array
Source
reconfiguration operation.
Indicates that the array is a temporary array in an
Temp
array reconfiguration operation.
The RAID-5 set is not redundant. The Unprot array
Unprot
state typically displays during the creation of the
RAID-5 set. Upon completion of RAID-5 set creation,
the CLI replaces the Unprot state with the Normal
state.
The RO Column
This column displays the letters RO if the array is read-only.
Otherwise, if the array is read-write the column displays a blank
space. You can explicitly make an array read-only and read-write
command for more information
7-9)
container Commands
5-59