container set io_delay
To set the I/O delay for an array, use the container set
io_delay command. You can specify an I/O delay for the
following array-related tasks:
Creating a mirror set
Creating a multilevel array of mirror sets from a multilevel
array of volume sets
Scrubbing a redundant array
You use this command to change the I/O delay from the one you
specified in the command for the previously listed tasks. The I/O
delay value is not preserved between reboots of the operating
system.
Syntax
container set io_delay {container} {integer}
Parameters
{container}
Specifies the ID number (0 to 63) of the array on which to set
the I/O delay.
{integer}
Specifies the number of milliseconds the controller waits
between the I/O operations required to perform the specified
background task. The I/O delay value is not preserved
between reboots of the operating system. Valid values are 0
through 100.
container Commands
5-104