Related Information - Adaptec RAID 2810SA Software Reference Manual

Use the container list command after using the container
add_level command to display information about the multilevel
volume set, as in the following example:
AAC0>container list
Executing: container list
Num Total Oth Stripe
Dr Label Type Size Ctr Size
-- ----- ------ ------ --- ------ ------- ------ -------------
0 Volume 45MB
63 Stripe 45MB
The following list describes the change to the display as a result of
creating a multilevel volume set with the container add_level
command:
The Num Label column displays two ID numbers. The first ID
(0) is the newly created volume set. The second ID (63) is the
original array (the stripe set).
If you specified a label when creating the multilevel volume
set, it appears in this column. Because no label was specified
when the multilevel volume set was created, no label appears
in the column.
The Type column displays two array types: Volume and Stripe.
The Volume array type indicates that the newly created array is
a volume set. This is the array created after the container
add_level command completes.
The Stripe array type indicates the array whose ID was
specified to the container add_level command. This is
the original array previously created with the container
create stripe command.

Related Information

container commands:
container extend mvolume
container list
container promote
Scsi Partition
Usage C:ID:L Offset:Size
None
32KB 0:02:0 64.0KB:
0:03:0 64.0KB:
0:04:0 64.0KB:
(page 5-46)
(page 5-54)
(page 5-69)
container Commands
15.0MB
15.0MB
15.0MB
5-4