Adaptec RAID 2810SA Software Reference Manual page 100

Table 5-4. Task Types (Continued)
Task Meaning
A rebuild task is running on the specified array.
Rebuild
Typically, the rebuild task runs when the controller is
in a rebuild for a redundant array (RAID-5 set, mirror
set, or multilevel array of mirror sets).
An array reconfigure task is running on the specified
Reconfg
array. When the array reconfigure task completes, the
specified array becomes a different array (for example,
from a volume set to a stripe set). The array
reconfigure task runs as a result of using the
container reconfigure
A scrub task is running on the specified redundant
Scrub
array. When the scrub task completes, the specified
redundant array has reconstructed data on one
partition based on data found on the other partition
(for mirror sets and multilevel arrays of mirror sets).
Or, the specified redundant array recalculates and
replaces, if necessary, the parity information (for
RAID-5 sets). The scrub task runs as a result of the
container scrub
runs as a result of the
command with the
A verify with no repair of bad blocks task is running
Verify
on the specified SCSI disk. When the verify with no
repair of bad blocks task completes, the specified SCSI
disk's blocks were verified without repairing any
detected defects. The verify with no repair of bad
blocks task runs as a result of using the
verify
switch.
A verify with repair of bad blocks task is running on
VfyRepl
the specified SCSI disk. When the verify with repair of
bad blocks task completes, the specified SCSI disk's
blocks are verified with repairs. The verify with repair
of bad blocks task runs as a result of using the
verify
A clear disk task is running on the specified SCSI disk.
Zero
When the clear disk task completes, the specified SCSI
disk is cleared (that is, all data is erased and cannot be
recovered). The clear disk task runs as a result of using
the
disk zero
command.
command. The scrub task also
container create raid5
switch specified.
/scrub
command without specifying the
command with the
/repair
command.
container Commands
disk
/repair
disk
switch.
5-61