Adaptec RAID 2810SA Software Reference Manual page 56

The following list describes the change to the display as the result of
creating a multilevel stripe set with the container create
mstripe command:
The Num Label column displays the ID number (in the
example, 0) of the newly created multilevel stripe set and
(indented to the right) the ID numbers of the arrays that make
up the multilevel stripe set. In the example, arrays 63 and 62
are the arrays (mirror sets) that make up the multilevel stripe
set.
If you specify a label when creating the multilevel stripe set, it
appears in this column. Because no label was specified when
the multilevel stripe set was created, no label appears in the
column.
On UNIX systems, the root special file associated with the
multilevel stripe set also appears in this column.
The Type column displays the type Stripe for the newly
created multilevel stripe set. The Type column also displays
the array type for the underlying arrays. In the example,
Mirror appears in the Type column to indicate that the arrays
that make up the multilevel volume set are mirror sets.
The Total Size column displays the total size for the multilevel
stripe set. This size is the total of all the underlying arrays. In
the example, the total size for array 0 (the multilevel stripe set)
is the sum of the two underlying arrays (30 MB).
The Total Size column also displays the sizes of all the
underlying arrays. In the example, the size of array 63 (15.0
MB) and array 62 (15.0 MB) were specified when the mirror
sets were created with the container create mirror
command.
The Stripe Size column displays the stripe size specified for
the multilevel stripe set. In this example, the display shows 32
KB, the default stripe size.
The Usage column displays None to indicate that the newly
created multilevel stripe set does not have a file system on it.
To create an NTFS or FAT file system on an array, use the
container format command.
container Commands
5-17