Boolean; Integer; Switches; Syntax - Adaptec RAID 2810SA Software Reference Manual

boolean

A boolean has a value of either TRUE or FALSE and can be specified
with any of the following key words:
TRUE can be specified with TRUE, 1, ON, or YES. For switches,
you can also specify TRUE by using the switch without any
switch value. For example, /readonly and /
readonly=TRUE are identical.
FALSE can be specified with FALSE, 0, OFF, or NO. When a
switch is not specified, it takes the default value (usually,
FALSE) specified in the switch description section of a
command. For example, open aac0 is the same as
open /readonly=FALSE aac0 .

integer

An integer is a positive or negative number that has a value between
63 63
–2 and (2 – 1). Although the valid range is usually much smaller,
all integers have 64 bits of precision and do not contain decimal
points.
You can specify an integer as a mathematical equation that uses an
asterisk (*) to multiply, a plus sign (+) to add, a minus sign (–) to
subtract, a slash (/) to divide, and parentheses [( )] to specify order
of operations. If you do not use parentheses, all operations are
completed left to right. No spaces are allowed in the expression.
Numbers in an equation that:
Begin and end with no suffix are decimal
Begin with 0x or end with h are hexadecimal
End with o indicate octal
End with z indicate binary
You can attach special multipliers to the end of any number to allow
for easy translation to reasonable disk sizes. Table 3-1 lists the letters
and their multiplicative values:
Syntax and Conventions for CLI Commands
3-5