Extend an existing file system
You can extend an existing file system by specifying the
appropriate switch. (The command extends the file system
after completing the reconfigure operation.)
Move partitions to other disks
You can move an array's partitions to other disks by specifying
the appropriate switches with a valid partition or partitions.
For example, you can move three entries of a RAID-5 set to
new disks.
You can combine the previously listed operations.
Notes
Some reconfigure operations result in destination sizes slightly
different than what you specified.
When you perform an array reconfigure operation on a UNIX
operating system you may see a resource conflict-related error.
Typically, this error occurs when there is not enough space on the
disk to perform the reconfigure operation. To correct the problem,
use another disk (with more space) to perform the reconfigure
operation.
Syntax
container reconfigure [/stripe_size{=integer}]
[/extend_fs{=boolean}][/mirror{=boolean}]
[/partition_move{=boolean}]
[/partition_size{=integer}] [/raid5{=boolean}]
[/raid10{=boolean}][/volume{=boolean}]
[/wait{=boolean}] {container} [{scsi_device}...]
container Commands
5-77