container create mvolume
To create a multilevel volume set, use the container create
mvolume command. You can create the following types of
multilevel volume sets:
Volume set of stripe sets
Volume set of mirror sets
Volume set of RAID-5 sets
Volume set of volume sets
Notes
When creating a multilevel array of volume sets on a NetWare
server, you specify the container IDs (as described in the Parameters
section) for the arrays from which you want to create the multilevel
volume set. If NetWare is using any of these arrays, an appropriate
message displays. This message indicates that one or more of the
arrays you specified is in use by NetWare. The message directs you
to remove any NetWare volumes and partitions from these arrays.
You can then create a multilevel array of volume sets on a NetWare
server.
After you create a multilevel volume set you can run the list
devices command on the NetWare console to verify its creation
and then create the necessary NetWare disk partitions and volumes.
For information on how to create partitions and volumes, see the
appropriate NetWare documentation.
Syntax
container create mvolume [/label{=string}]
{container} [{container}...]
Parameters
{container}
Specifies the ID number (0 to 63) of the array from which you
want to create the multilevel volume set.
container Commands
5-19