Task List; Syntax; Parameters; Switches - Adaptec RAID 2810SA Software Reference Manual

task list

To display a list of one or all tasks running on the currently opened
controller, use the task list command. A task is an operation that
occurs only on the controller, asynchronous to all other operations.
Clearing a disk, creating a file system, and creating a mirror set are
examples of tasks done on the controller.
The command displays an appropriate message if there are no tasks
running on the controller.

Syntax

task list [/all{=boolean}]

Parameters

{integer}
Specifies the task ID for the task whose information you want
to display. You need to perform a task list /all to display
all tasks and their associated IDs.

Switches

/all{=boolean}
Specifies whether to display all currently running tasks. If you
set this switch to TRUE, the command displays a list of all tasks
running on the currently opened controller.
This switch defaults to FALSE if you specify the integer
parameter; otherwise, the switch defaults to TRUE.

Examples

The following example shows typical output as a result of using the
task list command.
AAC0> task list
Executing: task list
Controller Tasks
TaskId Function Done%
------ -------- ------ ---------
101 Scrub 24.6%
Array State Specific1 Specific2
----- ---------
0 SUS 00000000
task Commands
--------
00000000
9-2