Related Information; Examples - Adaptec RAID 2810SA Software Reference Manual

As the following example shows, there is an array 0 (a mirror set) on
this controller:
AAC0>container list
Executing: container list
Num Total Oth Stripe
Dr Label Type Size Ctr Size
-- ----- ------ ------ --- ------ ------- ------ -------------
D: 0 Mirror 10.0MB
The following example assigns two SCSI failover disks to array 0. If
you assign only one SCSI disk as a failover device, ensure that there
is sufficient freespace. If you assign more than one SCSI disk as
failover devices, you need ensure that only one of these disks has
sufficient space. The reason for this is that the failover operation will
look for the disk that has enough space.
AAC0>container set failover 0 (0,3,0) (0,4,0)
Executing: container set failover 0 (CHANNEL=0,ID=3,LUN=0)
(CHANNEL=0,ID=4,LUN=0)
Use the container show failover command after using the
container set failover command to display information
about the array just assigned failover disk(s).

Related Information

container commands:
container list
container remove failover
container show failover
Scsi Partition
Usage C:ID:L Offset:Size
NTFS 0:02:0 64.0KB:
0:02:0 10.0MB:
(page 5-54)
(page
(page 5-112)
container Commands
10.0MB
10.0MB
5-86)
5-101