Container Create Volume; Notes; Syntax; Parameters - Adaptec RAID 2810SA Software Reference Manual

container create volume

To create a volume set from freespace, use the container create
volume command.

Notes

If you created a volume set you can run the list devices
command on the NetWare console to verify its creation and then
create the necessary NetWare disk partitions and volumes.
For information on how to create partitions and volumes, see the
appropriate NetWare documentation.

Syntax

container create volume [/cache{=boolean}] [/
label{=string}] {scsi_device},{free_space}
[{scsi_device},{free_space}...]

Parameters

{scsi_device}
Specifies the ID for the SCSI device whose freespace you want
to use for creating the volume set. A SCSI ID consists of a SCSI
bus number (e.g., 0, 1, 2, 3, etc.), SCSI device ID (0 through 15
inclusive), and SCSI device logical unit number (0 through 7
inclusive). See the installation guide for your controller to
determine the number of buses it actually supports.
See the scsi_device section on page 3-7 for more
information on how to specify the SCSI device.
Note that you must explicitly specify the entire ID for the SCSI
device (the SCSI channel number, device ID, and device logical
unit number).
{free_space}
Specifies the freespace used to create the volume set on the
specified SCSI device. See the free_space section on
page 3-8 for more information on how to specify the freespace.
container Commands
5-35