Related Information - Adaptec RAID 2810SA Software Reference Manual

The Type column displays RAID-5 to indicate that the newly
created array is a RAID-5 set.
The Total Size column displays the total size of the freespace
available. In this example, 40.0 MB of freespace was specified,
which means that this column displays 30.0 MB as available.
The Stripe Size column displays the stripe size you specified
as the stripe_size parameter, which in the example is 64
KB.
The Usage column displays None to indicate that the newly
created RAID-5 set does not have a file system on it.To create
an NTFS or FAT file system on an array, use the container
format command.
The State column displays the state of an array, which in the
example shows Unprot to indicate that the RAID-5 set is not
yet redundant. This means that the command has not
completed the creation of the RAID-5 set. If the
command is executed after the RAID-5 set completes
list
execution, the State column is blank.
(Note that this column appears only if you specify the /full switch
with the container list command.)
The Scsi C:ID:L column displays the SCSI device ID(s) for the
disk(s) on which you created the RAID-5 set, which in the
example are: 0:02:0, 0:03:0, 0:04:0, and 0:05:0.
The Partition Offset: Size column displays the partition
offset(s) and size(s) of the newly created RAID-5 set, which in
the example is 64.0 KB and 10.0 MB respectively.

Related Information

commands:
container
container list
container set cache
container set label
(page 5-54)
(page 5-97)
(page 5-107)
container Commands
container
5-29