Related Information - Adaptec RAID 2810SA Software Reference Manual

Dr Label Type Size Ctr Size
-- ----- ------ ------ --- ------ ------- ------ -------------
F: 0 Volume 30M
63 Mirror 15MB
62 Mirror 15MB
The following list describes the change to the display as the result of
creating a multilevel array of mirror sets with the container
create mmirror command:
The Dr column is blank to indicate that the newly created
mirror sets (63 and 62) do not have a drive letter assigned to
them.
The Type column displays Mirror for arrays 63 and 62 to
indicate that the underlying arrays are mirror sets.
The State column displays the state of the arrays, which in this
example are all in the Normal state.
Note that this column appears only if you specify the /full
switch with the container list command.
The Scsi C:ID:L column displays the SCSI device ID for the
disk(s) on which the underlying mirror set(s) reside. In the
example, mirror set 63 resides on disk 0:02:0 and 0:04:0. Mirror
set 62 resides on disk 0:03:0 and 0:05:0.
The Partition Offset:Size column displays the partition
offset(s) and size(s) for the underlying mirror set(s). In the
example mirror set 63 and 62 have partition offsets of 64.0 KB
and sizes of 15.0 MB.
If a partition is dead, the ":" (colon) in the Partition Offset:Size
column changes to a "!" (exclamation point). See the disk
remove dead_partitions
more information on dead partitions.

Related Information

container commands:
container create mirror
container list
container promote
Usage C:ID:L Offset:Size
NTFS
0:02:0 64.0KB:
0:04:0 64.0KB:
0:03:0 64.0KB:
0:05:0 64.0KB:
7-9) command for
(page
(page 5-5)
(page 5-54)
(page 5-69)
container Commands
15.0MB
15.0MB
15.0MB
15.0MB
5-12