Container Extend Mvolume; Command And Switch Availability; Syntax; Parameters - Adaptec RAID 2810SA Software Reference Manual

container extend mvolume

To extend a multilevel volume set by adding one or more arrays to
it, use the container extend mvolume command. Any file
system on the multilevel volume set remains intact, and can be
extended to include the added space.

Command And Switch Availability

This command and its associated switches (if any) are supported on
the following operating systems:
Windows NT
Windows 2000 (basic disk only)
Windows XP (basic disk only)

Syntax

container extend mvolume
{container} [{container}...]

Parameters

{container_to_extend}
Specifies the ID number (0 to 63) of the array to extend.
Typically, this array is a multilevel volume set.
Specifies the ID number (0 to 63) of the array to add to the
previously specified multilevel volume set. If a file system
exists on this array, the command displays an appropriate
error message and does not allow you to create the multilevel
volume set. This prevents the loss of any data residing in files
on the array.
container Commands
{container_to_extend}
5-46