Adaptec RAID 2810SA Software Reference Manual page 221

Table 9-1. Task Types (Continued)
Task Type Meaning
NTFSfmt An array format NTFS file system task is running on the
specified array. The format NTFS file system task runs as a
result of using the
file_system
Rebuild A rebuild task is running on the specified array. Typically,
the rebuild task runs when the controller is in a rebuild of a
redundant array (RAID-5 set, mirror set, or multilevel array
of mirror sets).
Reconfg An array reconfigure task is running on the specified array.
When the array reconfigure task completes, the specified
array becomes a different array (for example, from a
volume set to a stripe set). The array reconfigure task runs
as a result of using the
command.
Scrub A scrub task is running on the specified redundant array.
When the scrub task completes, the specified redundant
array has reconstructed data on one partition based on data
found on the other partition (for mirror sets and multilevel
arrays of mirror sets). Or, the specified redundant array
recalculates and replaces, if necessary, the parity
information (for RAID-5 sets). The scrub task runs as a
result of the
also runs as a result of the
command with the
This is the task type displayed in the example.
Unknown An unknown task is running.
array format
switch set to NTFS .
array reconfigure
array scrub command. The scrub task
array create raid5
switch specified.
/scrub
task Commands
command with the
/
9-4