Container Set Label; Syntax; Parameters; Examples - Adaptec RAID 2810SA Software Reference Manual

container set label

To assign a new label to the specified array or to assign a label to an
array that has no label, use the container set label command.
The following commands have a
assign a label to the array when you create it:
container create mstripe (a multilevel stripe set)
container create mvolume (a multilevel volume set)
container create raid5 (a RAID-5 set)
container create stripe (a stripe set)
container create volume (a volume set)
The label you specify with the container set label command
and the /label switch associated with the previously listed
container create commands is not the label that displays in
Windows Explorer. The label displayed by Windows Explorer comes
from the label specified with the container format command.

Syntax

container set label {container} {string}

Parameters

{container}
Specifies the ID number (0 to 63) of the array to which you
want to assign a label.
{string}
Specifies the label you want to assign to the array. The label is a
string of up to sixteen characters.

Examples

Before assigning a label to a specific array, use the container
list command to obtain information about any existing arrays.
As the following example shows, there is an array 0 (a volume set)
on this controller with no label assigned to it (as evidenced by no
label in the Num Label column):
AAC0>container list
container Commands
switch that allows you to
/label
5-107