Task Stop - Adaptec AAR-21610SA Reference Manual

task stop

To stop one or all tasks running on the currently opened controller,
use the task stop command.
Syntax
task stop [/all{=boolean}]
Parameters
{integer}
Specifies the task ID for the task to stop. Perform a task
list /all to display the task IDs for all tasks currently
running on the open controller before stopping a specific task
or all tasks.
Switches
/all{=boolean}
Specifies whether to stop all running tasks. If you set this
switch to TRUE, the command stops all tasks that were
running on the currently opened controller.
If you do not specify this switch or a valid task ID, the
command displays an appropriate error message.
Examples
Before stopping a running task, use the task list command to
identify any currently running tasks, as in the following example:
AAC0>task list
Executing: task list
TaskId Function
------ --------
101 Scrub
The following example shows the use of the task stop command
to stop task 101:
AAC0> task stop 101
Executing: task stop 101
Done% Array
----- ---------
24.6% 0
State Specific1
----- ---------
RUN 00000000
task Commands
Specific2
---------
00000000
8-10