Adaptec RAID 2810SA Software Reference Manual page 65

If you specify TRUE for both the /scrub and /clear
switches, the command displays an appropriate error message
and returns to the prompt.
/stripe_size{=integer}
Specifies the stripe size for the RAID-5 set. Valid values are
16 KB, 32 KB, and 64 KB.
If you do not specify a value for this switch, it defaults to
64 KB.
/label{=string}
Specifies a label to be assigned to the newly created RAID-5
set. You can specify a maximum of sixteen characters for the
label.
If you do not specify the switch, it defaults to no label. If you
do not specify a label, you can do so later by using the
container set label command.
Note that this label is not the label that displays in Windows
Explorer. The label displayed by Windows Explorer comes
from the label specified with the container format
command.
/scrub{=boolean}
Specifies whether to set up the parity during RAID-5 creation
by scrubbing the RAID-5 set. If you set this switch to TRUE, the
command sets up the parity by scrubbing the RAID-5 set.
Although the drive is immediately available, it is not parity-
protected until the background scrub action completes.
This switch defaults to TRUE.
If you set this switch to FALSE, the command will set up parity
by clearing the RAID-5 set. In other words, setting /
scrub=FALSE enables the same behavior as /clear=TRUE.
This switch is supported on the following operating systems:
Windows NT
Windows 2000
Windows XP
NetWare
container Commands
5-26