Use the
container list
command to display information about the array you
reconfigure
just reconfigured, as in the following example:
AAC0>container list
Executing: container list
Num
Total
Oth Stripe
Dr Label Type
Size
Ctr Size
-- ----- ------ ------ --- ------ ------- ------ -------------
0
Mirror 15.0MB
Tigris
E: 1
Stripe 15.0MB
As the result of reconfiguring an array (in this example, array 1)
with the container reconfigure command, the Type column
displays Stripe (instead of Volume) to indicate that the specified
array is now a stripe set instead of a volume set.
Related Information
container commands:
container create mirror
container create raid5
container create stripe
container create volume
container extend file_system
container list
command after using the
Scsi
Partition
Usage
C:ID:L Offset:Size
None
1:02:0 64.0KB:
1:03:0 64.0KB:
NTFS
1:00:0 64.0KB:
(page
5-5)
(page
5-24)
(page
5-30)
(page
5-35)
(page
(page
5-54)
container Commands
container
15.0MB
15.0MB
15.0MB
5-43)
5-82