Adaptec RAID 2810SA Software Reference Manual page 60

The following example shows how to create a multilevel volume set
from two single arrays:
AAC0> container create mvolume 0 1
Executing: container create mvolume 0 1
container 0 created
On UNIX systems, the message displayed after you execute the
container create mvolume command includes the root special
file associated with the newly created multilevel volume set.
Use the container list command after using the container
create mvolume command to display information about the
multilevel array of volume sets after you create it, as in the following
example:
AAC0>container list
Executing: container list
Num Total Oth Stripe
Dr Label Type Size Ctr Size
-- ----- ------ ------ --- ------ ------- ------ -------------
0 Volume 60.0MB
63 Stripe 45MB
62 Stripe 15MB
The following list describes the columns that contain information as
a result of creating a multilevel volume set with the container
create mvolume command:
The Num Label column displays the ID number (in the
example, 0) of the newly created multilevel volume set and
(indented to the right) the ID numbers of the arrays that make
up the multilevel volume set. In the example, arrays 63 and 62
are the stripe sets that make up the multilevel volume set.
If you specify a label when creating the multilevel volume set,
it appears in this column. Because no label was specified when
the multilevel volume set was created, no label appears in the
column.
On UNIX systems, the root special file associated with the
multilevel volume set also appears in this column.
Scsi Partition
Usage C:ID:L Offset:Size
None
64KB 0:02:0 64.0KB:
0:03:0 64.0KB:
0:04:0 64.0KB:
64KB 0:05:0 64.0KB:
container Commands
15.0MB
15.0MB
15.0MB
15.0MB
5-21