Command And Switch Availability; Syntax; Parameters; Examples - Adaptec RAID 2810SA Software Reference Manual

Command And Switch Availability

This command and its associated switches (if any) are supported on
the following operating systems:
Windows NT
Windows 2000 (basic disk only)
Windows XP (basic disk only)

Syntax

container extend file_system {container}

Parameters

{container}
Specifies the ID number (0 to 63) of the array whose file system
you want to extend.

Examples

Typically, you would use the container extend file_system
command after adding a level to an array and, perhaps, after
extending a multilevel volume set.
Before extending a file system, use the container list
command to obtain information about any existing arrays:
AAC0>container list
Executing: container list
Num Total Oth Stripe
Dr Label Type Size Ctr Size
-- ----- ------ ------ --- ------ ------- ------ -------------
E: 0 Volume 300MB
63 Volume 100MB
62 Volume 100MB
61 Volume 100MB
The following list describes the sequence that caused the previous
example to display:
1
Create a volume set of 100 MB on disk (1,0,0) with the
container create volume command.
2
Add a level to the volume set created in Step 1 with the
container add_level command.
container Commands
Scsi Partition
Usage C:ID:L Offset:Size
NTFS
1:00:0 64.0KB:
1:01:0 64.0KB:
1:02:0 64.0KB:
100MB
100MB
100MB
5-44