Honda FourTrax Foreman Rubicon 2005 Service Manual page 96

MAINTENANCE
REAR SUSPENSION INSPECTION
Replace damaged components which cannot be
repaired.
Tighten all nuts and boils.
SWINGARM BEARINGS INSPECTION
Raise the rear wheels off the ground by placing a
jack or block under the engine.
Check for worn swingarm pivot bearings by grab-
bing the rear axle housings and attempting to move
the swingarm side to side.
Replace the pivot bearings
if
any looseness is noted
(page 15-9).
SPARK ARRESTER
3-24
Remove the three bolts and the spark arrester with
the gasket.
Use a brush to remove carbon deposits from the
screen mesh, being careful not to damage the
screen mesh.
The screen mesh must be free of breaks and holes.
Replace the spark arrester if necessary.
Install the spark arrester with a new gasket and
tighten the three bolts.
TORQUE: 12 N·m (1.2 kgf·m, 9 Ibf.ft)
BOLTS
SPARK ARRESTER