Honda FourTrax Foreman Rubicon 2005 Service Manual page 535

MODE SELECT SWITCH ('05-'08 only)
INSPECTION
Turn the ignition switch OFF.
Disconnect the ECM 21 P (Black) connector.
Check for continuity between the ECM connector
terminals in each switch position .
Continuity should exist between the color coded
wires as follows:
~r
Orange
Bluel 81ackJ Green
Position
blado:: green
01
01
ESP
If the continuity is abnormal, disconnect the mode
select switch 4P (Black) connector, and perform the
inspection at the 4P (Black) connector in the same
manner as the previous step .
• If the continuity at the ECM is abnormal and con-
tinuity at the 4P connector is normal. check for an
open or short circuit, or loose or poor connector
contact .
• If the both continuities are abnormal, replace the
mode select switch.
REPLACEMENT
Remove the handlebar cover (page 14-7).
Remove the screw.
Remove the mode select switch from the cover
while pushing in the stoppers.
Install the new switch by aligning the locating tab
with the groove in the cover.
Install and tighten the screw.
HONDAMATIC
24-39