Advertisement
If the motor does
not
stop, disconnect
the engine
control module (ECM) 21P
connector and check
for
short
circuit
in Black/blue wire
between
the ECM
and
engine
coolant temperature (ECT)
sensor.
Fan
motor does not stop wh en the
temperature
indicator
goes
off
Remove the right front mud
guard
and right inner
fender
(page
2-9), and disconnect the fan motor 2P
(Natural)
connector
and engine
control
module
(ECM) 5P (Black)
connector.
Check for
short circuit
in
Green/bl
ack
wire
between
the
ECM
and
fan
motor.
Fan motor
does
not
start
Remove the following:
-
recoil
starter cover
(page
2-4)
-
fuel
tank cover
(page 2-6)
-
air intake duct (page 6-10)
Disconnect the
engine coolant temperature (ECT)
sensor connector
and ground the
connector
termi
-
nal
(Black/blue) with
a jumper
wire.
Turn the ignition
switch
ON
and check
the fan
motor.
If the motor
starts, check
the ECT
sensor (page
22-
21
1.
If the
motor
does not start,
disconnect
the
engine
control
module (ECM)
5P (Black) connector and
ground the
connector
terminal
(Green/black) with
a
jumper
wire.
Turn the
ignition
switch ON
and check
the fan
motor.
If the motor
starts, check
for
open circuit in
Black/
blue w
i
re between the ECT
sensor and
ECM.
LIGHTS/METERS/SWITCHES
22-19
Advertisement
