Advertisement
ELECTRIC POWER STEERING (EPS)
7. Fully turn the handlebar to the left and hold
it.
8. Make
sure
the engine stop switch is turned to
M
O
"and
turn the
ignition
switch to ON
.
The
EPS
indicator
lights and it goes
off
after 4 seconds.
9.
Within 4
seconds
after the EPS indicator goes
off,
release the
handlebar.
The
EPS
indicator comes
HANDLEBAR
on again
4 seconds
after releasing the handlebar.
EPS
INDICATOR
EPS INDICATOR
lO.Within 4
seconds
after
the EPS indicator
comes
, - -
-~~.::~=:±~~~~g~:;;:==-l
on, fully turn the handlebar to the left and hold
it.
EPS I
The EPS indicator goes
off
4 seconds after hold-
ing
the handlebar.
Leh
The rorque sensor
11.Within 4
seconds
after the EPg
indicat
or goes
off,
IS
mltlallzed of thiS
return the handlebar within
1
second to straight
HANDLEBAR
25-14
rime
ahead
and release the handlebar.
The EPS
indi-
cator blinks
twice 4
seconds
after releasing the
handlebar then EPS indicator blinks three times 5
seconds after
blinking the EPS
indicator.
Straight
NOTE
•
If the EPS
indicator
does not blink twice, an
error
was made
in
the procedure and the torque
sen·
sor was not initialized.
Turn the ignition
switch
OFF,
and
repeat the operation from step 3.
12.Turn
the ignition
switch
OFF after the EPS
indica-
tor blinks three
times.
13.Aemove
the
special
t
ool
from the OLC and con-
nect the OLC to the
dummy
connector.
14.lnstall the following
-
insulator rubber
-
seat (page
2·4)
EPS INDICATOR
Advertisement
