Honda FourTrax Foreman Rubicon 2005 Service Manual page 359

Remove the snap ring.
Drive the bearing out of the brake panel.
Drive a new bearing into the brake panel with its
sealed side facing out (facing the axle housing)
using the special tools as shown.
TOOLS :
Driver
Oil seal driver attachment
Pilot, 28 mm
07749·0010000
07JAD· PH80101
07746·0041100
Install the snap ring into the groove .
Pack a new dust seal lips with grease.
Install the dust seal into the brake panel until it flush
with the brake panel.
ApplV grease to the new brake cam dust seal lips.
Install the dust seal until it is seated.
BRAKE SYSTEM
16-23