Advertisement
FRONT WHEEL/SUSPENSION/STEERING
Install the tie-rod ball joint onto the knuckle with a
new nut, and tighten the nut while holding the joint
stud flats with an open
end
wrench
TORQUE
:
54 N'm (5.5
kgf·m,
40 Ibf.ft)
Install a new
cotter
pin.
Install the brake disc guard and tighten the brake
disc guard bolts.
Install the wheel hub (page 14-'8).
Install the front wheel (page 14-14), then place the
vehicle
on level ground.
Tighten the lower arm pivot nuts to the specified
torque.
TORQUE:
44 N
'm
(4.5 kgf·m,
33 Ibf.ft
)
STEERING SHAFT (Except EPS model)
REMOVAL
14-28
Remove the screw and handlebar upper
cover.
-
inner
fenders (page
2-9)
-
front fender
(page
2-11)
-
screw and handlebar upper cover
-
nuts
-
handlebar front
cover
HANDLEBAR UPPER COVER
~
Advertisement
