Advertisement
FRONT WHEEl/SUSPENSION/STEERING
Install the tie-rods into the
st
eering shah arm.
Install the new nuts and tighten them by holdi ng the
ball joint stud flats w ith an open end w rench.
TORQUE: 54 N ·m (5.5 kgf·m
,
40 IbUt)
Install new
cot
ter pins.
Install the
handlebar
assembly onto the steering
shaft with the washers and new lower holder nuts,
and tighten the nuts.
TORQUE:
39 N 'm (4.0 kgf·m
,
29 Ibf·ft)
Install the meter/assist headlight assembly onto the
steering shaft and tighten the two nuts.
TORQUE
:
25 N ·m (2.6 kgf·m
,
19
Ibf·ft)
Install the handlebar upper cover and tighten the
screw.
Install the front fender (page 2-11).
Install the inner fenders
(page
2-9).
HANDLEBAR UPPER COVER
~
14-33
Advertisement
