Advertisement
FRONT WHEEL/SUSPENSION/STEERING
THROTTLE HOUSING
DISASSEMBLY
Remove the following:
-
three screws
-
throttle housing cover
-
gasket
Slide the boot off the throttle cable adjuster.
loosen the
lock nut and cable adjuster.
Bend down
the lock washer tab and remove
the
pivot
nut, lock washer, throttle arm, return spring,
throttle
lever and washer.
Disconnect the
throttle cable from the throttle arm.
Remove
the dust seal from the
housing
bottom.
ASSEMBLY
Coal a new dust seal lip with grease and install
it
into
the throttle housing
until
it
is
fully seated.
Apply grease
to
the throttle lever pivot.
Apply grease
to
the throttle cable end and connect
the
cable to the throttle arm.
Install
the washer onto the
throttle
lever
and
insert
the
lever into the throttle housing.
Install the throttle arm with the return spring over
the
throttle lever pivot by aligning the flat surfaces.
Install a new lock washer and
the
pivot
nut.
Tighten
the
pivot nut and bend
up
the
lock
washer
tab
against the nut.
Install the throttle housing
cover
with a new gasket.
14-13
Advertisement
