Advertisement
INITIALIZING THE TORQUE SENSOR
NOTE
Perform this procedure using a fully charged bat-
tery.
The
EPS
indicator
will stay lit and the ECU will
abort the process if you
use
a low or dead battery.
How to
Initialize
the
Torque
Sensor
with HOS
1.
Raise the front wheels off the ground and sup-
port the ATV wilh a jack or work
stand.
2. Remove the dummy connector and connect the
HOS
Pocket
Tester
to the OLe.
Turn the ignition switch to
ON.
Turn the handlebar straight
ahead.
Initialize the Torque Sensor with the
HOS
while
the engine is slopped.
-
Follow the instructions on the
HDS
display.
How to
Initialize
the
Torque
Sensor
with
Ole
NOTE
'
The OTe will be erased when initializing the torque
sensor.
1. Remove the seat (page
2-4),
2. Remove the
insulator
rubber.
3.
Turn
the ignition switch
to
OFF.
4. Remove the dummy connector and short the
Brown/red and Green wire terminals of the DLC
using the special tool.
TOOL:
SCS connector
070PZ-ZY30100
CONNECTION: Brown/
red
-
Green
ELECTRIC POWER STEERING (EPS)
I
D"MY CONNECTOR
DLC
SCS CONNECTOR
OLC
5. Raise the front wheels off the ground and sup-
;:::==========
=
==-=====:
port the ATV with a jack or work
stand.
6.
Place a 6 mm screwdriver between the steering
shah arm and the steering stopper plate as
shown.
ARM
25-13
Advertisement
