Honda FourTrax Foreman Rubicon 2005 Service Manual page 213

CENTRIFUGAL CLUTCH
Coat 8 new O-ring with oil and install it onto the oil
feed pipe setti ng
cap.
Install and tighten the setting cap.
TORQUE: 18 N ·m (1.8 kgf·m , 13 Ibf.ft)
Install the left engine side cover stay by aligning the
~S~T~A~Y~~~~C~O~L~L~A~R~S~~~~~~:~~~
locating tab with the groove in the rear crankcase
~ '
cover, and tighten the two bolts. '-
Install the left engine side
cover
and collars then
tighten the bolt and socket bolts.
Install the following:
BOLTS
- oil tank (page
4-8)
j
- gearshift linkage (page
7-10)
I/"'~
- inner fenders (page 2-9)
- front mud guards (page 2-8)
Adjust the tie-rod length of the gearshift lever link·
age (page 12-'8).
SOCKET BOLTS
CENTRIFUGAL CLUTCH
DISASSEMBLY
Remove the front crankcase
cover
(pag e
10-2).
Be careful nor ro Unstake the centrifugal dutch lock nut .
damage the
crankshaft threads
Install the special tools by aligning th e pins with the
grooves in the drive plate.
Hold the drive plate and loosen the lock nut
TOOLS:
Clutch holder set
- clutch holder plate
- clutch holder pin
01ZMB·HN20000
or
07ZMB·HN2Al00
(U.S.A. only)
07ZMB·HN20100
07ZMB·HN20200
Remove the lock nut and washer.
10-9