Advertisement
FRONT
WHEEL/SUSPENSION/STEERING
INSTALLATION
Apply molybdenum disulfide grease to the pivot
bushing contact area of the pivot collar and install it
i
nto the
upper
arm.
Apply molybdenum disulfide grease to the new
dust
seal
cap lips and
i
nsta
l
l them onto the upper
arm.
Install the upper arm
int
o the frame with the
pivot
bolt and a new nut, and tighten the nut.
TORQUE:
34 N 'm (3.5 kgf·m
,
25 Ibf.ft)
Connect the shock absorber to the upper arm w ith
the lower mounting bolt and a new nut, and tighten
the nut.
TORQUE:
44 N·m 14.5 kgf·m
.
33
Ibf.ft)
Install the lower arm into the frame with the two
pivot bolts and the new nuts, and loosely tighten
the nuts.
Install the brake hose clamps and tighten the brake
hose clamp bolts.
TORQUE: 12
N ·m
(
1.2 kgf·m
, 9
Ibf·ft
)
Tighten the ball joint castle nuts to the specified
torque and further tighten until their grooves align
with the cotter pin holes.
TORQUE:
29 N 'm (3.0 kgf·m
,
21
Ibf.ft)
Install the new cotter pins.
:11
~
SEAL
CAPS
14-27
Advertisement
