Advertisement
ENGINE REMOVAL/INSTALLATION
7-12
Connect the angle sensor and control motor
can·
nectars, and secure
their
wires with the wire clip
and
band.
Connect
the
crankcase breather hose to
cylinder.
Install
the starter motor cable onto
the
terminal and
tighten the nut.
Install the ground
cable and
tighten the
bolt.
Install
the rubber
cap over the terminal
properly.
Install the
ground cable
terminal
onto
the
engine
and
tighten the
bolt.
Adjust
the
tie-rod length of the gearshift lever
link-
age (page
12-18).
Install the
following:
-
heat guard (page 8-6)
carburetor (page 5-18)
exhaust system (page 5-61
right
and left inner fender (page 2-9)
right
and left front
mud
guards (page 2-8)
right
and
left
center
mud
guards (page 2-7)
Fill the oil tank with recommended engine oil (page
3-14).
Fill and bleed the cooling system (page 6-5)
.
Check the engine oil level (page 3-12).
Advertisement
