Honda FourTrax Foreman Rubicon 2005 Service Manual page 268

CRANKSHAFT I AUTOMATIC TRANSMISSION
Be
careful not to
let
the connectmg rod
press fIglImsl the
cran/(case mating
surlace while
drawing
13-12
CRANKSHAFT AND BALANCER
INSTALLATION
ApplV engine oil to a new rear crankshaft bearing.
Drive the crankshaft bearing into the rear crankcase
with the marking side fa cing up.
TOOLS:
Driver
Attachment, 78 x 90 mm
Pilot, 32 mm
07749-0010000
07GAD-SD40101
07MAD-PR90200
For front crankshaft bearing replacement, see page
13-13.
Engage the balancer and crankshaft by al igning the
index lines on the side surfaces of the balancer
drive and driven gears and install the crankshaft and
balancer together int o the fear crankcase.
Assemble the special tools onto the crankshaft.
Draw the cranksha ft into the bearing inner race.
TOOLS:
Assembly collar
Threaded shaft
Threaded adaptor
07965-VM00100
07965-VM00200
not available in U.S.A . or
07931-ME4010B and
07931-HB3020A
(U.S.A . only)
07965-VM00300
not available in U .S.A . or
07931-KF00200
(U.S.A. only)
After i nstalling the crankshaft in, make sure that the
index lines on the crank weight and balancer driven
gear are aligned.