Advertisement
HONDAMATIC
REPLACEMENT
Shift the sub· transmission
into
neutral.
Remove the two bolts and gear position switch from
the crankcase cover.
Remove the D-ring.
Coat a new
O-ring
with engine oil and install
it
onto
a new gear position switch.
Align the long end of
the switch
pin with
the
"N"
mark.
Install the gear position switch by aligning the
switch
pin
with
the slot in
the
crankcase
cover
being
careful not to damage the switch pin.
Install the bolts and tighten them.
ESP SHIFT SWITCH
•
The automatic transmission can shift
and
the
meter
indicates
the
shift
posit
ion (1 through 5)
with the following conditions:
-
Mode select switch at
ESP
(Electric Shift
Pro-
gram)
-
Gearshift lever (Sub-transmission) in 0
range
-
Engine
is running
INSPECTION
Turn the
ignition
switch
OFF.
Disconnect the ECM 21P (Black) connector.
Check for continuity between the ECM connector
terminals in
each
switch position.
Continuity should exist between the
color
coded
wires as follows:
~
White1
BlacIJ
white1
Black!
Position
blue
"d
yellow
"d
Up
Free
Down
'05.
'06.
If the
continuity
is abnormal, remove the handlebar
switch 10P (Green)
connector from the frame and
disconnect
it.
After
'06.'
If the
continuity
is abnormal, remove the handlebar
switch 14P
(Green)
connector from the frame and
disconnect it.
24-38
Perform the
inspection
at the
lOP
(Green)
connect
or
in the same manner as
the
previous step.
•
If the continuity at the EeM is abnormal and
con-
tinuity at the lOP
(Green)
connector is normal,
check for an open or short circuit, or loose or
poor connector
contact.
•
If the both
continuities
are abnormal.
replace the
handlebar switch
(shift
switch) (page
14-7).
Advertisement
