Query Command; Real Time Event - Christie Mirage S+/HD/WU User Manual

Appendix C: System Integration
Example 1.
Turn room lighting ON when the projector is turned OFF. (Assumes a control/automation unit is configured to
turn the lights ON when pin 2 of its input goes hi (12-2009)gh.)
C.1.2 Query Command
(GIO?)
(GIO! "HHLLHLH" "OOIOOOI")
(GIO? C2)
(GIO! C2 O)
(GIO? 2)
(GIO! H)
C.1.3 Real Time Event
Use the serial command RTE to specify an action that is initiated at a particular time or based on an external
stimulus.
For General Purpose IO "G"
Parameter
P1
P2
P3
P4
Example 2.
Projector powers up when a switch on the external device is turned ON.
(GIO C2 I)
(RTE G 2 H "(PWR 1)")
(RTE G 2 L "(PWR 0)")
C-2
(GIO C2 O)
(GIO 2 H)
Name
RTE type
I/O bit
Pin state
(1 Character)
(String)
Commands
Set pin #2 configuration to output
Set pin #2 to high (state)
Request the state and configuration of all pins
Reply of pin state and configuration
Request configuration for pin #2
Reply with pin #2 configuration as output
Request the state of pin #2
Reply with pin #2 state as high
G (Real Time I/O Event)
1-7
H = High
L = Low
"LHXXXHLX" Combine multiple inputs and trig-
ger occurs when all conditions are met
Any valid serial protocol command for the
device
Set pin #2 configuration as input
Power on when pin #2 set to high
Power off when pin #2 set to low
Roadster, Matrix WU, Mirage S+/HD/WU User Manual
Value
020-100002-06 Rev. 1 (04-2011)