List Of Picture In Picture; Serial Control Interface - Christie LWU505 User Manual

DVI
o : Picture in Picture combinations are enabled.
x : Picture in Picture combinations are disabled.
Note:
or images may not be displayed on the Main/Sub picture.
<Display resolution is lowered when;>
<Images are not displayed and X mark appears when;>
<Picture in Picture is disabled when;>
This projector provides a function to control and monitor the projector's operations by using the RS-232C
serial port.
Operation
1 Connect a RS-232C serial cross cable to CONTROL
PORT on the projector and serial port on the PC.
(See p.19)
2 Launch a communication software provided with PC
and setup the communication condition as follows:
Baud rate : 9600 / 19200 bps
Parity check
Stop bit
Flow control
Data bit
3 Type the command for controlling the projector and
then press the "Enter" key.
Example
When you want to change the input to INPUT 2,
Type 'C' '0' '6' and press the Enter key.
LWU505 User Manual
020-000374-01 Rev.1 (01-2011)

List of Picture in Picture

DVI
X mark will be displayed on the Main/Sub picture.

Serial Control Interface

: none
: 1
: none
: 8
Appendix
Note:
19200 bps
Note:
Enter with ASCII 64-byte capital
characters and one-byte characters.
89