Freeze Image; Color Enable - Christie Mirage HD User Manual

System Configuration
DIAGNOSTICS / CALIBRATION
Mirage S+/HD, Matrix S+/HD, Christie HD/DS/DW, DLV User's Manual
020-100001-04 Rev. 1 (12/07) - Software v1.6g or higher
Intelligent Lens System (ILS
ILS™ provides the ability to recall focus and zoom settings specific to each source
input. Custom lens settings you've chosen for any source will be quickly and
accurately applied when you select a source that has already been calibrated. Place a
checkmark in the checkbox to enable ILS™. If no calibration has previously been
done you may be prompted to do a full calibration. If a motion calibration has been
done, you will be prompted to complete a reference calibration. If both calibrations
have been done, the checkbox will be checked and ILS™ enabled. If ILS™ is enabled,
a reference calibration will be done on power up and the lens will return to the saved
position of the source that is active at the time of power up or to the position the lens
was located when it was powered on. Further adjustments to the zoom, focus and
position will be automatically saved for source the selected source. If you switch to a
source with different lens settings and switch back, the lens will automatically move
to your saved settings upon return. Other sources can be used without using ILS™ .
NOTES: 1) See System Configuration – Diagnostics/Calibration, ILS Calibration
for further details about calibration. 2) ILS
be retained between power cycles.
Test Pattern
Choose the desired internal test pattern to
display, or select OFF to turn off a test
pattern. Alternatively, use the
for cycling through test patterns.
NOTE: There is a centerline (both
horizontal and vertical) in the Edge
Blending test pattern. The intersection of
these lines is the true center of the
projector's display area.
Test Pattern Grey Level
Set the desired level of grey for displaying in the full gray field test pattern.

Freeze Image

Enter a check mark to freeze (stop) an image on a single frame. This diagnostic tool is
useful if you need to examine in detail a still version of an incoming image that cannot
be "frozen" at the source. For example, in moving images it is sometimes difficult to
observe artifacts such as external de-interlacing/resizing and signal noise. Remove the
checkmark to return back to normal.

Color Enable

Select which color or colors you want to see. This is useful while working with color
temperature, input levels or other special setup parameters. Colors can also be
enabled/disabled by entering the corresponding function code listed on the back of the
standard remote keypad.
.
™
)
— SUBMENU
™
control is a preference setting and will
1.
2.
3.
4.
5. Odd Pixel Adjustment
key
Test
6.
7.
8.
9.
0. Aspect Ratio Overlay
LiteLOC Calibration
Automatic ILS Lens Calibration
Section 3: Operation
Diagnostics and Calibration
Test Pattern
Grid
Grey Level
512
Freeze Image
Color Enable
White
Reserved
Peak Detector
Level Detector
Level Value
512
Calibrate LiteLOC
ILS Calibration
Full Calibration
3-49