Red, Green Blue And White X, Y; Auto Color Enable; Color Enable; Reset To Factory Color Primaries - Christie Entero RPMWU-LED01 Service Manual

Section 7: Service Menu

7.1.1 Red, Green Blue and White X, Y

Selecting each of these items allows a different value to be entered using the remote. The value entered
represents the X or Y coordinates of the selected color point.

7.1.2 Auto Color Enable

Checking the box (Figure 7-1, item 10) automatically selects Color Enable based on the control being
adjusted.

7.1.3 Color Enable

This control allows the primary colors (red, green and blue) to be turned ON or OFF separately. It is used to
look at the colors one at a time or in pairs when doing convergence, light measurements, etc. Secondary colors
(yellow, cyan and magenta) can also be observed one at a time.

7.1.4 Reset to Factory Color Primaries?

Selecting this option will reset all primaries to their factory default settings. Once selected, the user is given the
opportunity to leave the settings as-is without resetting them to factory defaults.
7.2

Replace Backplane

• Service Menu > Replace Backplane
The projector serial number and other factory settings are located on the backplane, and will be lost when a
defective backplane is replaced. Settings must be transferred to another module before powering the projector
down. The unit should then be disconnected from all power sources, replace the defective backplane, and
power up the unit again. On the next power up, the settings will automatically be transferred to the new
backplane.
NOTE: After selecting this item, an option to cancel the operation is provided.
7.3

Remote Access Level

• Service Menu > Remote Access Level
This option allows the remote serial protocol access level to be set for ethernet, RS-232 and RS-422 ports.
Choices available are Free Access, No Access or Login Required.
7.4

Restore Factory Defaults

• Service Menu > Restore Factory Defaults
Factory defaults of any type can be set by selecting this control. To restore all defaults, the command must be
entered with a value of 111. Once selected, an option to cancel is provided.
Unlike Reset to Factory Color Primaries, which only updates the color primary values, this option (Restore
Factory Defaults) restores many settings (including the color primary settings).
7-2 Entero RPMSP/RPMWU/RPMHD-LED01 Service Manual
020-100368-05 Rev. 1 (06-2012)