Dce Enable; Description - Zte ZXR10 8900 Series Command Reference Manual

ZXR10 8900 Series Command Reference (Basic Configuration Volume II)
Syntax

Description

Defaults
Example
Purpose
Command Modes
Syntax
Defaults
Instructions
Example
Purpose
Command Modes
Syntax
Syntax

Description

Defaults
Example
18 Confidential and Proprietary Information of ZTE CORPORATION
16
32
The crc is 16 by default.
� This example describes how to set the crc mode of the serial
port serial_1/1 as 32.
ZXR10(config)#interface serial_1/1
ZXR10(config-if)#crc 32
� This example describes how to set the crc mode of CT1 sub
interface as 32.
ZXR10(config)#interface ct1_1/1.1
ZXR10(config-if)#crc 32

dce enable

Use this command to set the work mode of synchronous serial port
to DCE.
Interface configuration

dce enable

DCE working mode
It is only applied to ZXR10 GAR, ZXR ZSR.
This example describes how to set the working mode of serial port
serial_1/1 to DCE.
ZXR10(config)#interface serial_1/1
ZXR10(config-if)#dce enable
description
Use this command to add a description for the interface. Delete
the description of the interface with the no command.
Interface configuration and channelization configuration
description <string>
no description
<string>
No description
This example describes how to describe a 100M Ethernet interface.
ZXR10(config)#interface fei_2/1
ZXR10(config-if)#description "this is FastEthernet Interface"
Set a 16-bit crc
Set a 32-bit crc
Description of the interface, with 200
characters at most