File Data Modes; Table 19 File Data Mode Stored Measurements - Olympus 38DL PLUS User Manual

DMTA-10004-01EN, Rev. D, November 2016
11.2.2

File Data Modes

When you create a data file on the 38DL PLUS, you must select the file data mode to
determine which measured values to store in the file (see step 3.f in "Creating a Data
File" on page 163). Table 19 on page 182 describes the available file data mode
options. You can only store one type of data in a file.
File data mode
THICKNESS
THRU COAT
TEMP COMP
OXIDE LAYER
VELOCITY
MIN/MAX
TIME OF FLT
REDUCTION RT
182 Chapter 11

Table 19 File data mode stored measurements

Stored measurements
Standard thickness
Echo-to-echo thicknesses
Coating thickness
Material thicknesses
Material temperature
Material thickness
Oxide thickness
Material thickness
Velocity
Minimum thickness
Maximum thickness
Time of flight
Material thickness
Reduction rate
When to use
When basic thickness
measurement functions
When using THRU-COAT (see
"Measurements with THRU-
COAT D7906 and D7908
Transducers" on page 78)
When using temperature
compensation (see "Using
Temperature Compensation" on
page 156)
When using the optional oxide
software (see "Oxide Layer
Software Option" on page 93)
When performing velocity
measurements
When using the MIN/MAX mode
(see "Using the Minimum,
Maximum, or Min/Max Thickness
Mode" on page 115)
When measuring time of flight
When the reduction rate
differential mode is activated (see
REDUCTION RT in "Using
Alarms" on page 117)