Table 11 Additional Information Stored With The Data - Olympus 38DL PLUS User Manual

DMTA-10004-01EN, Rev. D, November 2016

Table 11 Additional information stored with the data

For a measurement
File name
File header data
Identifier
Units (in. or mm)
LOS (loss-of-signal)
Differential mode
Differential reference value
Alarm mode
Alarm status
Alarm set points
Minimum or maximum mode
Minimum or Maximum Reading
Velocity
Resolution
Transducer setup number and information
Coating thickness
(when THRU-COAT is active)
Temperature
(when temperature compensation is active)
Oxide thickness
(when Oxide Measurement is active)
You can store approximately 475000 thickness values without waveforms in the
internal memory or approximately 20000 thickness values with waveforms. You can
double the storage capacity by using an optional external microSD memory card. The
maximum size of the external microSD card that can be used on the 38DL PLUS is
2 GB.
With the datalogger, you can easily create a data file (see "Creating a Data File" on
page 163), perform a number of file operations (see "Performing File Operations" on
page 183), add notes (see "Notes" on page 192), and perform data operations (see
"Setting the ID Overwrite Protection" on page 196).
162 Chapter 11
For a waveform
Zoom status
Horizontal axis limits
Detection marker position
Delay
Range
Rectification mode