Table 15 Resulting Id Example For The 2D+Custom Pt File Type - Olympus 38DL PLUS User Manual

Table 15 Resulting ID example for the 2D+CUSTOM PT file type

Parameters
START COLUMN
END COLUMN
START ROW
END ROW
To create a 2-D grid with custom points data file
1. From the measurement screen, press [FILE], and then select CREATE in the menu
(see "Creating a Data File" on page 163 for details on the first parameters).
2. At the bottom of the CREATE screen, select CONTINUE.
3. In the second page of the CREATE screen (see Figure 11-11 on page 176):
a) Enter the START COLUMN, END COLUMN, START ROW, and END ROW
values.
b) Enter two or more CUSTOM POINTS values.
c) Press [2nd F], [] to finish entering CUSTOM POINTS values.
d) In INC 1ST BY, select which parameter increments first (POINT, ROW, or
COLUMN).
e) In INC 2ND BY, select which parameter increments second (POINT, ROW, or
COLUMN).
f) Select CREATE.
DMTA-10004-01EN, Rev. D, November 2016
CUSTOM
Values
POINTS
A LEFT
J CENTER
01 RIGHT
17
Resulting IDs
A01LEFT
A01CENTER
A01RIGHT
A02LEFT
...
J17RIGHT
Using the Datalogger 175