Table 14 Resulting Id Example For The Seq+Custom Pt File Type - Olympus 38DL PLUS User Manual

Table 14 Resulting ID example for the SEQ+CUSTOM PT file type

START ID
XYZ1267
The allowable number of characters for each custom point depends on the ID number
of characters defined in the start and end ID values. The total number of characters of
the ID value plus the custom points cannot exceed 20 characters. For example, when
the start and end ID values are seven characters long, as in the example in Table 14 on
page 169, the maximum allowable length for each custom point is thirteen (20 – 7 =
13).
To create a sequential data file with custom points
1. From the measurement screen, press [FILE], and then select CREATE in the menu
(see "Creating a Data File" on page 163 for details on the first parameters).
2. At the bottom of the CREATE screen, select CONTINUE.
3. In the second page of the CREATE screen (see Figure 11-6 on page 170):
a) Enter the START ID and END ID values.
b) Enter two or more CUSTOM POINTS values.
c) Press [2nd F], [] to finish entering CUSTOM POINTS values.
d) Select CREATE.
END ID Custom points
XYZ1393 TOP
BOTTOM
LEFT
RIGHT
DMTA-10004-01EN, Rev. D, November 2016
Resulting IDs
XYZ1267TOP
XYZ1267BOTTOM
XYZ1267LEFT
XYZ1267RIGHT
XYZ1268TOP
XYZ1268BOTTOM
XYZ1268LEFT
...
XYZ1393RIGHT
Using the Datalogger 169